Model
230 Drum Unloader with Air Ram (or optional Hydraulic ram)
The 230 Melts and pumps
a wide variety of hot melt coatings, sealants
and adhesives, including "shear sensitive"
UV coatings, moisture curable urethanes, wax
based inks, food-grade resins, "water-block";
cable seal-ants and pressure sensitive adhesives,
to name a ' few. A "Workhorse" of
the insulated glass industry, the, Model 230
and its Model 030 predecessor have been pumping
butyl based window sealants for over 24 years.
|
|
| Standard
Specification & Features |
Overall
Size: Width - (Control Box face to cross
beam junction box)-59 inches (75 inches for 480 VAC Unit)
- depth - 31"; height (beam fully raised)-116 inches.
Weight:
1,300 lbs. (empty) (1,800 lbs. 480 VAC Unit).
Air
Requirements: (PSI) -80 Min., 150 Max.
(Hydraulic RAM Optional.)
Air
Consumption: Less than 1 SCFM Continuous.
Electrical
Service: 208/230 VAC, 3 ph, STD. (480Vopt.)
50/60 HZ, 100 AMP Entrance.
Power
Consumption: 82 AMPS/At 230 VAC (Start-Up
Only) 57 AMPS Continuous.
Temperature
Range: 100 F to 550 F (Depending on Platen
Style)
Material
Flow Rate: Up to 1400 lbs./hr. Depending
on hot melt type and Platen Style.
Material
Viscosity: 100 CPS to 20 Million CPS
Start-Up
Time: Less than 20 minutes. (From 65°F)
Total
“Drum Change” Flow Interruption:
Less than 5 minutes.
- Patented
"SEG-O-SEALÒ” Segmented Drum Seals.
Damaged Seal Section can be replaced by "Tapping
In" repair plug (Even on hot Platen).
- 34
KW (Optional 52 KW) Platen with 6,000 Sq. in. Finned
Heat Transfer Area (Model 181)
- PLC
Machine Control w/ Touch Screen Operator Interface
- PLC-Based
Temperature Controller
- Touch
Screen Temperature Display
- Run/Stand-By
Temperature Settings
- Over-heat
and Low Heat Alarm & Auto Shutdown
- Toe
Clamp" Drum Hold-down Device
- High
Pressure Flexible Heated Hose with Dual Platinum RTD's
and JIC Swivel end Fittings, 5/16” ID thru 2"
ID, Teflon-Lined
- 13
Ton Capacity Ram Cylinders-(Convertible from Air to
Hydraulic)
- Rugged
Positive Displacement Gear Pump with Hardened Internals
- Operates
with Fiber or Steel Drums
- 1-1/2"
(or optional 3”) Solid Steel Base Plate
- DC
Permanent Magnet or AC Inverter Duty, Variable Speed
Pump Motor (1 HP STD, 2 & 5 HP Optional)
- Sonic
Empty-Drum Alarm
- Heated
"Drum Entry" Air Bleed Valve with Release
Coated Collector Pan & Safety Guard (Model 308)
- O-Ring
Face Seal, 4-Bolt, Pump Outlet Port (Accepts Optional
Multi-Hose Manifold.)
- Release
Coated Platen Drip Tray, (Model 078)
- Positive
Pressure Platen Wiring Chamber
|
